Back
Do not tighten any corners at this point. The frame will be loose and awkward to handle but you will get used to this quickly.
Now...
put the frame into the Fast 'R-Frame joining machine to tighten the wedges.
©1999
by Frame Tek, Inc.
|
Back
|
|
1 2 | |||||||||
|
||||||||||||
| 1. Lay the Fastware corners on the table like this. | ||||||||||||
|
||||||||||||
| 2. Insert wedges into the corners as far towards the corner as possible and press down firmly. Leave the Fastware corners on the table "Wedges Up". Lay the frame members "Face Up" on the table. | ||||||||||||
|
||||||||||||
| 3. Slide 3 adjacent frame members"Onto" the Fastware corners. | ||||||||||||
Do not tighten any corners at this point. The frame will be loose and awkward to handle but you will get used to this quickly. |
||||||||||||
|
||||||||||||
| 4. With the loose frame laying "Face Up" on the table, slide the glass/art/backing package into the frame as shown. Insert the fourth side. You may find that making a right angle "fence" out of foam core strips on the table will give you 3rd and 4th hands to help. | ||||||||||||
Now... |
||||||||||||
|
©1999
by Frame Tek, Inc.
|
||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|